Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Attention! Input results shown will be +/- 10% from middle value. Hint: The closer your min and max inputs are, the more accurate your results will be!

Compression Spring Part Number System - In Inches

The Spring Store Part Number System For Compression Springs in Inches

P

Part Number

C

Compression Spring

030

Wire Diameter

-250

Outer Diameter of Spring

-9500

Total Coils

-MW

Material Type

-1000

Free Length

-CG

End Type

-Z

Finish

-IN

Unit of Measure

Our Part Numbers Have Changed

Since we have created the new website, we have updated our dimensional part numbers to not have any decimal points. However, we have kept the three decimal spaces so remember to add the extra zeros where needed.

Previous Part Number

PC030-250-9.500-MW-1.000-CG-Z-IN

New Part Number

PC030-250-9500-MW-1000-CG-Z-IN

The Spring Store By Acxess Spring Part Number System In Inches For Compression Springs

We have developed an easy stock spring part number system using the actual dimensions of the spring. This part number system for springs was developed to facilitate the creation and understanding of part numbers for springs. By using the actual dimensions of the spring in the spring part number we have made our part numbers for springs simple, but yet descriptive of the actual measurements of the spring in real time. Our part numbers consist of a series of numbers to describe each individual spring. Each part number is separated by hyphens to indicate different dimensional characteristics of a spring. Each series describes a different dimension. Below you will find a breakdown explanation of how The Spring Store part number system works for compression springs in inches.

  • The letter P stands for Part Number
  • The letter C stands for Compression Spring
  • The first series of numbers indicates Wire Diameter=WD
  • The second series, following the first hyphen, indicates Outer Diameter=OD
  • The third series, following the second hyphen, indicates Total Coils=TC
  • The fourth series, following the third hyphen, indicates Material Type
  • The fifth series, following the fourth hyphen, indicates Free Length=FL
  • The sixth series, following the fifth hyphen, indicates End Type
  • The seventh series, following the sixth hyphen, indicates Finish
  • The eighth series, following the last hyphen, indicates Unit of Measure Inches=IN

Please look at the part number example below for a further explanation.

Compression Spring Part Number Example In Inches:

PC030-250-9500-MW-1000-CG-Z-IN

  • P=Part Number
  • C=Compression Spring
  • 030=0.030 Wire Diameter=WD
  • 250=0.250 Outer Diameter=OD
  • 9.500=Total Coils=TC
  • MW=Material Type
  • 1.000=Free Length=FL
  • CG=End Type
  • Z=Finish
  • IN=Unit Of Measure Inches

Nomenclature:

Material Types: BC=Beryllium Copper, HD=Hard Drawn, MW=Music Wire, OT=Oil Tempered, PB=Phosphor Bronze, SPR=Spring Steel, SST=Stainless Steel

End Types: C=Closed Ends, CG=Closed and Ground Ends, O=Open Ends

Finish TypesBO=Black Oxide, GI=Gold Irridite, N=None, Z=Zinc

Unit of Measurement: IN=inches, MM=millimeters

The Spring Store By Acxess Spring Part Number System In Metric Millimeter For Compression Springs.